Plate Curing Equipment For Baking CTP & Conventional P.S. Plates
 

"Memory" Plate Curer is designed to Bake CTP & Conventional P.S. Plates. Sturdy mild steel Powder Coated fabrication. Operator friendly control panel includes main on/off, digital temperature meter with thermostat, Amp. meter & electronic timer with buzzer.
The oven is specially designed to save heat loss and is completely insulated thus avoids Hot Air in the surrounding areas. Thermostatically controlled Hot Air maintains inside temperature evenly thus ensures even baking at a temperature ranging from 220°C to 250°C.
Baking helps to give large print runs with same sharpness thus ensures smooth running on press and easy to store plates for repeat jobs.
Four plates can be baked at a time.

 
Palte Loading
 
Technical Specifications
Max. Plate Width 820 mm 1150 mm
Max. Plate Length 1060 mm 1450 mm
Line Voltage 3 Phase / 440 V 3 Phase / 440 V
Power Load 7.5 kw 15 kw
Dimensions (LxWxH) 1370x770x1840 mm 1960x770x2300 mm
Control Panel

Plate Processor
For CTCP & Conventional P.S. Plates

"Memory" Video Plate Punch & Bender is designed keeping in mind the growing demand of quality CTP Plates in commercial & Newspaper Web Presses. The machine is equipped with CCD Cameras to scan the CTP Plates up to 40 times magnification to register with PC Baseline. This ensures the quickest register for multi color printing on presses, thus saves time & paper cost, caused by traditional page make-up or printing down errors. The CTP Plate is fed manually on the feeder tray. Electronic sensor actuates the conveyor to transport the plate to Punching & Edge Bending station.
Register Marks specially exposed outside printing area are used for positioning & aligning the Plate with the help of Two CCO Cameras. Cameras record the register marks & transmit the image to the PC for comparing with Zero Position of each camera system. The display images on the monitor evaluates and sends the control signal for automatic aligning by a 3-Axis (X Y & R) Co-ordinate table to the correct position for punching & edge bending.
If one or both the register marks are outside the tolerance field, the plate is rejected and moved out from the system without punching & edge bending.

Technical Specifications
Plate Size Max 900 x 650
Hourly Output Max 200
Air Supply 7 - 10 Bar
Operation Pressure 6 Bar
Power Supply Single Phase, 220 Volts 50Hz
Positioning accuracy ± 0.015 mm
Input Tolerances for production ± 0.01-0.05 mm
Screen TFT 19"
Dimensions L / W / H 150 x 1400 x 1500 mm
Weight Net/Gross 800/1200 kgs

Optional

  • In-line Operation - The machine can be connected in-line to all known CTP Plate setters.

  • Conveyors & Corner Transfer Units can be supplied for custom configurations.

 
©Reprographic Systems & Supplies